Exhaust Pipe/Muffler; Exhaust System Inspection; Front Suspension Inspection - Honda 2010 CRF250R Service Manual

MAINTENANCE
Remove the clutch cable end adjuster.
Apply grease to the clutch cable end adjuster inside
surface.
EXHAUST PIPE/MUFFLER
EXHAUST SYSTEM INSPECTION
Check the joint band bolt and jOint nuts for looseness
and exhaust gas leaks.
Tighten each bolt and nut of the exhaust system to the
specified torque.
TORQUE :
Exhaust pipe joint nut: 21 N'm (2.1 kgf-m, 15Ibf·ft)
Muffler joint band bolt : 21 N'm (2.1 kgf'm, 151bHt)
SUSPENSION
FRONT SUSPENSION INSPECTION
CABLE END ADJUSTER
Check the action of the forks by operating the front .---,..--~-------------,
brake, and compressing it several times.
Check the entire assembly for signs of leaks, damage
or loose fasteners.
Make sure the fork protectors and dust seals are clean
and not packed with mud and dirt.
Remove any dirt thai has accumulated on the bottom of
the fork seals.
Replace damaged components which cannot be
repaired.
Tighten all nuts and bolls.
For fork service (page 13-14).
3·28