Hpsd Removal/Installation - Honda 2010 CRF250R Service Manual

Route the Wiffi
properly
(page 1-21).
HPSD
FRONT WHEEL/SUSPENSION/STEERING
Install the clutch lever bracket and holder with the
punch mark on the holder facing up.
Align the end of the holder with the paint mark on the
handlebar.
Install and tighten the clutch lever bracket holder upper
bolt first, then the lower boll securely.
Install the holders, engine stop switch and screw on the
handlebar.
Align the center of each holder with the paint mark on
the handlebar as shown.
Tighten the engine stop switch screw to the specified
torque.
TORQUE:1.5 N'm (0.2 kgf-m,
1.11bHtJ
Clamp the engine stop switch wire with the wire bands.
Instal! the handlebar pad.
Adjust the clutch lever freeplay (page 3~26).
Inslalilhe number plale (page 2-5).
REMOVAL/INSTALLATION
Remove the number plale (page 2-5).
Remove Ihe sleering damper bolis, collar and steering
damper.
CLUTCH LEVER BRACKET/HOLDER
PAINT MARK
ENGINE STOP
SWITCH
'10 shown:
PAINT MARK
I
HANDLEBAR PAD
13-41