Shock Linkage Installation - Honda 2010 CRF250R Service Manual

REAR WHEEL/SUSPENSION
Apply specified grease (page 1-19) to the side collar
inside surfaces.
Install the pivot collars and side collars to the shock arm
(swingarm side, shock link side).
The shock link side pivot collar is longer than the
swingarm side pivot collar.
Apply specified grease (page 1-19) to new dust seal lips
and side collars.
Install the dust seals, pivot collar and side collars.
• Make sure the needle bearing rollers are in position
before installing .
Number of needle rollers: 32
Install the dust seals with the marking side facing
out.
INSTALLATION
Apply engine oil to the shock link and shock arm nut
threads and seating surface.
Loosely instalilhe following:
- Shock link
Shock link boltlnutlwasher (frame side)
Shock arm
SI DE COLLARS
'~rti
f)
SHOCK ARM
PIVOT COLLAR
Shock arm bolt/nut/washer (swingarm side)
Shock arm bolt/nut/washer (shock link side)
Shock absorber lower mounting bolt/nul (page 14-
I~~~~K
30)
Tighten the nuts to the specified torque.
TORQUE:
Shock link nut (frame side):
53 N'm (5.4 kgf'm, 39 IbHt)
Shock arm nut (swingarm side) :
53 N'm (5.4 kgf'm, 39 IbHt)
Shock arm nut (shock link side) :
53 N'm (5.4 kgf-m, 39 IbHt)
Shock absorber lower mounting nut :
44 N'm (4.5 kgf-m, 32 IbHt)
PIVOT COLLARS
•
(/
SIDE COLLAR
SIDE)
~
ARM
14-35