Brake System; Clutch System; Brake Lever Position; Brake Pedal Height - Honda 2010 CRF250R Service Manual

BRAKE SYSTEM
Apply silicone
grease to the
adjusting boll tip.
BRAKE LEVER POSITION
The brake lever position can be adjusted by loosening
the adjuster lock nut. and turning the adjusting bolt.
Turning the adjusting boll clockwise moves the brake
lever fa rther away from the g rip; turning the adjusting
bolt counterclockwise moves the brake lever closer to
the grip.
After adjustment, tighten the adjuster lock nut to the
specified torque while holding the adjusting bolt.
TORQUE : 5.9 N'm (0.6 kgf-m , 4.4 IbH t )
If the brake lever freeplay exceeds 20 mm (13/16 in),
there is air in the system that must be hied.
For brake system air bleeding (page 15-7).
BRAKE PEDAL HEIGHT
Adjust the brake pedal to the desired height by
loosening the push rod lock nUl, and turning the push
md.
STANDARD LENGTH: 79.6
mm (3. 13 in)
Tighten the push rod lock nut to the specified torque.
TORQUE
: 5.9 N·m (0.6 kgf·m , 4.4 IbHt)
CLUTCH SYSTEM
CLUTCH LEVER POSITION
LOCK NUT
Make sure 10 adjusl
The clutch lever position can be adjusted by loosening , - -
Ihe clulch lever
the adjuster lock nut, and turning the adjusting boll.
freeplay after Ihe
clutch lever position
adjustment or when
the clutch cable is
disconnected.
Turning the adjusting bolt coun terclockwise moves the
clutch lever farther away from the grip: turning the
adjusting bolt clockwise moves the clutch lever closer to
the grip.
After adjustment, tighten the adjuster lock nut securely
while holding the adjusting boll.
Check the clutch lever f reeplay (page 3-26).
I
NOTICE
Failure to check the clutch lever freep/ay may result in
damaged clutch plates.
--
MAINTENANCE
ADJUSTING
BO LT~
LESS THAN 20 mm
(13/16 in)
STANDARD LENGTH:
79.6 mm
(3.13
in)
ADJUSTtNG BOLT
0.:
LOCK NUT
3-25