Honda 2010 CRF250R Service Manual page 246

CLUTCHIKICKSTARTERIGEARSHIFT LINKAGE
Set the drum center in a position other than neutral.
While holding the ratchet pawls in place in the guide
plale and drum shifter, install the drum shifter assembly
by aligning the hole of the drum shifter with the shift
drum center pin, and guide plate -KRN- mark facing up
Inslall and lighten Ihe guide plale bolts securely.
Install the shifter collar onlo Ihe drum shifter.
Apply engine 011 to the gearshift spindle serration area .
Do not forget
10 Install Ihe washer and gearshift spindle assembly into
install the washer
the crankcase while aligning the spring ends with the
onlo Iha gearshift
crankcase stopper pin and Ihe spindle hole with the
spindle .
shifter collar.
Wipe off any oil from the gearshift spindle serration
~~~~~~~~
• • • • •
I.~~~~
area.
I
Install the gearshift pedal on Its original position as
marked during removal.
Tighten the bolito the specified torque.
TORQUE : 12 N·m (1.2 kgf·m, 9lbHt)
Move the gearshift pedal and check the shift
mechanism for smooth operation.
Install the clutch (page 10-12).
Install the right crankcase cover (page 10-6).
10-24