Honda 2010 CRF250R Service Manual page 281

CRANKCASE/CRANKSHAFTITRANSMISSION/BALANCER
Remove the crankshaft oil seals and bearings from both
crankcase halves.
Drive in a new Drive in a new crankshaft bearings into both crankcase
r:~,:,;::::,
beanng squarely
halves until they are fully seated, using the special
with the marking
tools.
side facing toward
the inside of the
TOOLS :
crankcase.
Right crankshaft bearing :
Driver
07749·0010000
Attachment,
72 x 75
mm
07746-0010600
Pitot, 30 mm 07746-0040700
Left c rankshaft bearing :
Driv er
07749-0010000
Attachment, 62
x
68 mm 07746-0010500
After installation, apply engine oil to the crankshaft
~g===~~r:~~~~~~IIII'=~IlC~
bearings.
Clean and apply locking agent to the crankshaft bearing
set plate torx screw threads as shown.
NOTE:
Use Pro Honda Hondalock 3 or equivalent high strength
locking agent.
6.5:!:1 .0mm
(0.26 ± 0.04 in)
3.0 -
4.0 mm
(0.12 - 0.16in)
Instalilhe lorx screws with the set plates and tighten Ihe
~================-~
tal")( screws to the specified torque.
TORQUE : 22 N-m (2.2 kgf'm , 16 IbHt)
12-27