Honda 2010 CRF250R Service Manual page 313

FRONT WHEEUSUSPENSION/STEERING
Hold the damper rod, install the fork cap assembly into
the fork damper.
'10 shown:
FQRKCAP
ASSEMBLY
FORK DAMPER
'10-
Set the fork damper in a vise wi th a piece of wood or
~=======::""'"==F=O=R=K=C=A=P==~
soft jaws to avoid damage. FORK DAMPER
Hold the fork d amper using the special tool.
TOOL:
Lock nut wrench , 50 mm 07WMA·KZ30100
Tighten Ihe fork cap assembly to Ihe specified torque
using th e special tool while holding the fork. damper.
TOOL:
Fork cap bolt holder, 36 mm
070MB·MEN0100 or
070MB·MENA100
(U.S.A. only)
TORQUE: 30 N·m (3.1 kgf'm , 22 IbHt)
BOLT HOLDER
After '10:
Set the fork damper in a vise with a piece of wood or
rFm!KIDAMPu'-------~
soft jaws to avoid damage.
Hold the fork damper using the special tool.
TOOL:
lock nut wrench, 50 mm 07WMA-KZ30100
Tighten the fork cap assembly to the specified torque
while holding the fork damper.
TORQUE : 30 N'm (3.1 kgf'm , 221bHt)
Hold the fork damper in an upright position and pump
~F~ O ~ R ~K~D~A~M~P~E~R~~~~~=======~
the fork piston rod 100 mm
(3.9
in) slowly, several
times.
PISTON R OD
~~
t
100 mm (3. 9
in)
13-27