Honda 2010 CRF250R Service Manual page 297

Replace the wheel
bearings in pairs.
Do
not reuse
old
bearings_
FRONT WHEEL/SUSPENSION/STEERING
Pack each wheel bearing cavity with grease,
Drive a new left wheel bearing in the wheel hub until it is
fully seated using special tools.
• Install the wheel bearing with the sealed side toward
the outside.
TOOLS :
Driver
Attachment, 37 x 40 mm
Pilot, 20 mm
07749·0010000
07746-0010200
07746-0040500
Install the distance collar into place , then drive a new
right wheel bearing using the same speciallools.
Pack the lips of a new right dust seal with grease, and
install it to the wheel hub.
Pack the lips of a new left dust seal with grease , and
1~~~~fF~~~~~~~~~~~~
install it to the wheel hub.
~
Do not gel grease
Install the brake disc onto the wheel hub with the
on the brake disc or
MDRIVE~ mark. facing oul.
stopping power will
be reduced.
Install the brake disc bolts and nuts .
Tighten the nuts to the specified torque.
TORQUE: 16 N·m (1 .6 kgf-m, 121bHt)
Check the right side collar for wear or damage .
Replace it if necessary.
Install the side collar to the right wheel hub.
13-11