Rear Brake Pads Replacement - Honda 2010 CRF250R Service Manual

Tighten the pad pin to the specified torque.
TORQUE : 18 N'm (1.8 kgf'm, 131bHt)
Install and tighten the pad pin plug to the specified
torque.
TORQUE: 2.5 N'm (0.3 kgf'm, 1.8IbHt)
Apply the brake lever to force the caliper piston out of
the caliper.
After
'12
only:
Install the front brake disc cover (page 13-13).
Rotate the wheel by hand. and check the brake
operation.
REAR BRAKE PADS REPLACEMENT
HYDRAULIC BRAKE
Always replace the
Push the caliper piston all the way in to allow
r ---.. ; ----..--- ".-- --...
~-~_,_.,
brake pads in pairs
installation of new brake pads.
to assure even disc
pressure.
NOTE:
Check the brake fluid level in the brake master
cylinder reservoir as this operation causes the level
to rise.
Remove the pad pin and brake pads .
Install new brake pads to the pad retainer and pad
~~~~f~~~~~~~~~~~~~q
spring securely.
l
NOTE :
Discard contaminated pads
contaminated disc with high
degreasing agent.
and clean a
Quality brake
15-13