Front Wheel Inspection; Front Wheel Disassembly; Axle Shaft Runout; Wheel Bearing - Honda 2010 CRF250R Service Manual

FRONT WHEEUSUSPENSION/STEERING
INSPECTION
AXLE SHAFT RUNOUT
Set the axle shaft on V-blocks and measure the runout.
Turn the axle shaft, and measure the runout using a dial
indicator.
Actual runout is 112 of the total indicator reading .
SERVICE LIMIT: 0.2
mm
(0.01
in)
WHEEL BEARING
AXLE
Tum the inner race of each wheel bearing with your , - - -- - - - -- - - - - - - - -,
finger.
The bearings should turn smoothly and Quietly.
Also check thatlhe bearing outer race fits tightly in the
wheel hub.
Rep/ace the Replace the wheel bearing,
if necessary (page
13-8).
bearings in pairs.
WHEEl RIM RUNOUT
Check the rim runoul by placing the wheelan a truing , - - - - -- - - - - - - - - - - -,
stand.
Spin the wheel
by
hand , and read the runout using a
dial indicator.
SERVICE LIMITS :
Radial : 2.0 mm (0.08 in)
Axial : 2.0 mm (0.08 in)
Check the spokes and lighten any that are loose.
DISASSEMBLY
'10 -
·,2
only:
Remove the brake disc cover from the left wheel hub.
13-8