Rear Fender Removal/Installation; Sub-Frame Removal - Honda 2010 CRF250R Service Manual

FRAME/BODY PANELS/EXHAUST SYSTEM
REAR FENDER
REMOVAL/INSTALLATION
Remove the following :
- Seat (page 2·3)
- Side covers (page 2·3)
Remove the mounting bolts and rear fender.
Installation is in the reverse order of removal.
TORQUE:
Rear fender mounting bolt :
13 N'm (1 .3 kgf'm, 10 IbHt)
SUB-FRAME
REMOVAL
Remove the following:
- Seal (page 2-3)
- Side covers (page 2-3)
- Muffler (page 2-9 )
'10· ',2: Disconnect the tAT sensor 2P (Gray) connector.
After
'12' Disconnecllhe tAT sensor 2P (Black) connector.
Loosen the air cleaner connecting boot band screw.
'10 shown:
/ REAR FENDER
,
~
...
,
-'
Be
careful nOllO
Remove the ECM with the rubber cover from the stay of
~~~~~~-===---========l
damago/he ECM the sub-frame.
r
and wires.
2-6
Unhook the fuel tank band from the fuel tank band
bracke\.