Honda 2010 CRF250R Service Manual page 326

FRONT WHEEUSUSPENSION/STEERING
Align the edges on the throttle pipe end with the lab and
~S mark of the right handlebar grip.
Align the tab on the left handlebar grip with the paint
mark on the handlebar.
RIGHT SIDE:
TAB
.
...
-
MARK
LEFT SIDE:
EDGES
PAINT MARK
Apply specified grease (page 1-19) to the throttle cable
~T~H~R~o~n~L~E~==T:;~~~~~~~~
ends and throttle pipe flange groove .
I
Connect the throttle cables to the throttle pipe. CABLE SOL T
13-40
Tighten the throttle cable bolt to the specified torque.
TORQUE: 4.0 N·m (0.4 kgf'm, 3.0 IbHt)
Install the throttle housing , aligning the end of the
housing with the paint mark on the handlebar.
Tighten the throttle housing upper boll first, then the
lower bolt.
Adjust the throllle grip freeplay (page 3-7),
Install the brake master cylinder and holder with the
·UP" mark on the holder facing up.
Align the end of the holder with the paint mark on the
handlebar.
Install and tighten the upper master cylinder holder boll
first, then the lower bolt to the specified torque.
TORQUE: 9.9 N'm (1 .0 kgf'm, 7.3 IbHt)
"
MASTER
PAINT
CYUNDER _ _ - "
· UP· MARK
BOLTS