Steering Shaft/Eps Unit (Fpm/Fpe Models) Installation - Honda TRX500FM Service Manual

FRONT WHEEUSUSPENSION/STEERING
Assemble the special tools and a 10 mm washers [1J
onto the steering bearing {2J.
Remove the bearing by tlgh tening the nut [3).
TOOLS :
[4] Clutch compressor 07LAE·PX40100
attachment
[5] Compressor bolt assembly 07GAE·PG40200 or
07GAE·PG4020A
(U .S.A. only)
[6) Attachment, 34 mm 07ZMD-MBW0100
1 41
1 5 1 __ .
1
(6)
- - '1:=cf-__
11 I
(3)
Drive a new bearing into the frame with the marked side
facing up.
TOOLS:
[1J Driver
{21 Attachment, 42 x 47 mm
[3) Pilot, 20 mm
01949·3710001
07746-0010300
07746-0040500
Make
sure the
snap Install the snap ring [1] into the groove properly with the
nng
is
firmly sealed
chamfered edge facing down.
in the groove.
16-36
INSTALLATION
Pack the seal lips of new dust seals [1] wi th grease.
Install each dust seal with the flat side facing out so that
it is flush with the frame edge.
(21