Installing The Toner Cartridge; Installing Other Options; Mounting The Accessory Parts; Connecting The Power Cord - Konica Minolta bizhub C236DN Service Manual

Security Function Ver. 1.01 May 2016
3.1.3

Installing the toner cartridge

Since a toner cartridge is not supplied with the machine, purchase one separately.
1. Shake the toner cartridge up and down and left to right 5 to 10 times respectively.
Shake the cartridge adequately. Otherwise, it may cause trouble.
2. Insert the toner cartridge into the machine. Make sure that the color is same between
inserting port and the toner cartridge. Make sure that the blue label position of the toner
cartridge is matched with the one of the machine side.
3. Push the toner cartridge all the way in and rotate it clockwise to lock it. Make sure that
the toner cartridge is pushed all the way in.
4. Close the front door.
3.1.4

Installing other options

See the "Installation procedures" of the installation manual for each option.
3.1.5

Mounting the accessory parts

1. Set the stylus pen.
2. Attach the supplied cord clamp to the scanner rear cover of the machine. (One supplied
screw)
This may not be performed depending on the applicable marketing area.
3. Attach the supplied connector cover to the machine. (One supplied screw)
4. Attach the supplied duct cover.
3.1.6

Connecting the power cord

1. Connect the power cord. This may not be performed depending on the applicable mar-
keting area.
2. Fit the supplied cord clamp over the power cord. (One supplied screw)
This may not be performed depending on the applicable marketing area.
3. Plug the power cord into the power outlet.
3.1.7

Starting the machine

1. Open the front door and turn ON the power switch, then close the front door.
3.1.8

Make the necessary settings

• Date & Time Setting/Time Zone Setting ([Service Mode]  [Date & Time Setting/Time
Zone Setting screen (To display the Date & Time Setting/Time Zone Setting screen,
press Stop  3 on the control panel)])
• Serial number input ([Service Mode]  [System 1]  [Serial Number])
• Unit change ([Service Mode]  [System 2]  [Unit Change])
3. Installation of the machine and steps to be
performed before operation
2