Show Mac Address-Table Static - Cisco Catalyst 3750 Command Reference Manual

show mac address-table static

show mac address-table static
Use the show mac address-table static user EXEC command to display only static MAC address table
entries.
Beginning with Cisco IOS Release 12.1(19)EA1, the show mac address-table static command replaces
Note
the show mac-address-table static command (with the hyphen).
Syntax Description address mac-address
interface interface-id
vlan vlan-id
| begin
| exclude
| include
expression
Command Modes
User EXEC
The address keyword is available only in privileged EXEC mode.
Command History Release
12.1(11)AX
12.1(19)EA1
Usage Guidelines Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Catalyst 3750 Switch Command Reference
2-334
show mac address-table static [address mac-address] [interface interface-id] [vlan vlan-id]
[ | {begin | exclude | include} expression]
(Optional) Specify a 48-bit MAC address; the valid format is H.H.H
(available in privileged EXEC mode only).
(Optional) Specify an interface to match; valid interfaces include physical
ports and port channels.
(Optional) Display addresses for a specific VLAN. The range is 1 to 4094.
(Optional) Display begins with the line that matches the expression.
(Optional) Display excludes lines that match the expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
The show mac-address-table static command was replaced by the show
mac address-table static command.
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
78-16181-01