Energy Saver - Xerox ColorQube 9201 System Administrator Manual

General Setup
2. Click on the [Status] tab.
3. Select [SMart eSolutions] in the directory tree.
4. Click on the [Maintenance Assistant] tab.
5. Click on the [Start an Online Troubleshooting Session at www.xerox.com] bar. A "Starting
Online Troubleshooting Session" message will display. When transmission is complete your
browser will automatically be redirected to Xerox.com for online assistant.
Note: If there are any communication problems, a message window will display. Check your
configuration and communication settings by clicking the [Settings] button. This will take you to
the SMart eSolution Setup page.
To Download File to Your Workstation:
1. At your Workstation, open the Web browser and enter the IP address of the device in the Address
bar, and press [Enter].
2. Click on the [Status] tab.
Select [SMart eSolutions] in the directory tree.
3.
4. Click on the [Maintenance Assistant] tab.
5. Click on the [Download File to Your Computer] bar. The Generating Diagnostic Information
screen will display, showing "This may take a few minutes".
6. Once the file is ready, File Ready screen will display, indicating "File Successfully generated".
Right-click on the link [UsageLog.csv] to download the file.
7. Select [Save Target As...].
8. Select the folder you want to save the file in and click on [Save].
9. Click on the [Close] button.
Note: If there are any communication problems, a message window will display. Check your
configuration and communication settings by clicking the [Settings] button. This will take you to
the SMart eSolution Setup page.

Energy Saver

This feature allows you to set the device to save energy when not in use. This feature can be set at the
device as well as at the web browser.
At your Workstation:
1. Open the web browser and enter the IP address of the device in the Address bar, and press
[Enter].
2. Click on the [Properties] tab.
3. If prompted, enter the Administrator User ID and Password. The default is [admin] and [1111].
Click on the [Login] button.
4.
5. Click on the [General Setup] link.
6. Click on [Energy Saver] in the directory tree.
7. In the Energy Saver Mode area, select one of the following mode for [Energy Saver Mode]:
• Intelligent Ready - the device wakes up and sleeps automatically based on previous usage.
• Job Activated - the device wakes up when an activity is detected.
38 Xerox ColorQube™ 9201/9202/9203
System Administrator Guide