Xerox ColorQube 9201 System Administrator Manual page 59

11. Once the device has completed the upgrade it will reboot automatically. The configuration report
will print (if it was enabled in the Tools set up). When the device is accessible from a web browser,
view the software version on Internet Services Manual Upgrade page, or check the configuration
report to verify that the software level has changed.
Note: Your device can be set to automatically schedule device software upgrades from a central
server at a specific time on a regular basis. For instructions click the Software Upgrade link to the
left of the page and select Auto.
You have completed the steps to perform a manual software upgrade.
Software Upgrade: Auto
Your device can be set to automatically schedule device software upgrades from a central server.
WARNING: This procedure will delete any current jobs in the device print queue and prevent
further jobs from printing until the upgrade has completed. If you wish to preserve these jobs,
allow them to complete before upgrading your software. All configured network settings and
installed options will be retained by the device after the Software Upgrade process.
Determine your current System Software Version number.
1. At your Workstation, open the web browser and enter the IP address of the device in the Address
bar, and press [Enter].
2. Click on the [Properties] tab.
3. If prompted, enter the Administrator User ID and Password. The default is [admin] and [1111].
4. Click on the [Login] button.
5. Click on the [General Setup] link.
6. Select [Configuration Report] in the directory tree, scroll down to the Common User Data section
to see your System Software Version.
7. Contact your Xerox Customer Support Representative to make certain that Auto Upgrading is
appropriate for your device. If it is not, refer to the Software Upgrade via Network Connection
topic for manual upgrade instructions.
8. Press the <Log In/Out> button, then touch [Logout] to exit the Tools pathway.
Set the Auto Upgrade Time
1. At your Workstation, open the web browser and enter the IP address of the device in the Address
bar, and press [Enter].
2. Click on the [Properties] tab.
3. If prompted, enter the Administrator User ID and Password. The default is [admin] and [1111].
4. Click on the [Login] button.
Click on the [General Setup] link.
5.
6. Click on the [Machine Software] link.
7. Select [Auto Upgrade] in the directory tree.
8. Check the [Enabled] checkbox to enable the Auto Upgrade feature.
Xerox ColorQube™ 9201/9202/9203
System Administrator Guide
General Setup
51