Xerox ColorQube 9201 System Administrator Manual page 96

Network Installation
b. Physical Connection displays the physical network connection, this will always display
"Ethernet".
9. Up to three ports may be enabled and configured, in the Port Information area:
a. For Port 1 Leave the [TCP Port Number] set to 9100. If two additional ports are available,
click [Default All] to see if they set to 9101 and 9102 respectively (emulating HP JetDirect EX
Plus 3).
b. Leave the [Bidirectional] checkboxes and [Maximum Connections per Port] settings at their
default values.
c. Set the [End of Job Timeout] to the number of seconds to wait before processing a job
without an End Of Job indicator. The range is from 1 to 65535, and the default is 300.
d. Leave the [PDL Switching] Enabled checkbox at its default value.
Note: Do not check the [Enabled] checkbox for PDL Switching, when Windows clients print using
port 9100. this prevents each print job from generating a banner page.
10. Click on the [Apply] button to accept the changes or [Undo] to return the settings to their
previous values, or [Default All] to enter printer defaults for all settings (recommended).
11. Click on the [OK] button when you see the message "Properties have been successfully
modified".
Note: The settings are not applied until you restart the device.
12. Click on the [Status] tab, select [Description & Alerts] in the directory tree.
13. Scroll down and click the [Reboot Machine] button and click [OK] to reboot the device. The
network controller takes approximately 5 minutes to reboot and network connectivity will be
unavailable during this time.
Create an IPP Printer (Internet Printing Protocol)
Information Checklist
Before starting the procedure, please ensure the following items are available or have been performed:
• Ensure TCP/IP and HTTP are configured on the device as per
Device on page 11, so that the web user interface (Internet Services) can be accessed.
• Ensure that the DNS settings are configured.
Enable Port 9100 as additional support for HTTP (IPP) printing
1. At your Workstation, open the web browser and enter the IP address of the device in the Address
bar, and press [Enter].
2. Click on the [Properties] tab.
3. If prompted, enter the Administrator User ID and Password. The default is [admin] and [1111].
4. Click on the [Login] button.
5. Click on the [Connectivity] link.
6. Click on the [Protocols] link.
Select [Raw TCP/IP Printing] in the directory tree.
7.
8. In the General area, ensure the [Enabled] checkbox for Protocol is checked to enable Raw TCP/IP
Printing.
88 Xerox ColorQube™ 9201/9202/9203
System Administrator Guide
Enable TCP/IP and HTTP at the