Windows Xp; Configure Tcp/Ip And Slp Settings - Xerox ColorQube 9201 System Administrator Manual

Network Installation

Windows XP

Configure TCP/IP and SLP Settings

1. At your Workstation, open the web browser and enter the IP address of the device in the Address
bar, and press [Enter].
Note: TCP/IP and HTTP should have been initially configured, refer to
the Device on page 11 of this guide and follow the steps provided.
2. Click on the [Properties] tab.
If prompted, enter the Administrator User ID and Password. The default is [admin] and [1111].
3.
4. Click on the [Login] button.
5. Click on the [Connectivity] link.
6. Click on the [Protocols] link.
7. Select [IP (Internet Protocol)] in the directory tree.
8. In the General area:
CAUTION: Disabling TCP/IP or changing the IP address will affect NetBIOS/IP, LPR/LPD, FTP,
SNMP and Raw TCP/IP printing. If TCP/IP is disabled, Internet Services will not be available until
TCP/IP is enabled from the device's control panel. If you change the IP address, you must
reference the new address within you web browser to locate the device.
a. Check the [Enabled] checkbox to enable the TCP/IP protocol.
b. Physical Connection will display the physical network connection. This will display
"Ethernet".
c. Select the on of the following method for obtaining a Dynamic IP address from the [IP
Address Resolution] drop-down list:
• DHCP (Dynamic Host Configuration Protocol)
• RARP (Reverse Address Resolution Protocol)
• BOOTP (Bootstrap Protocol)
• Static (fixed, User-defined), this is the default selection.
d. Enter a name which corresponds to the IP address of the device in the [Host Name] field.
e. If you select [Static], type the IP addresses that applies in [Machine IP Address], [Subnet
Mask], and [Gateway Address].
Note: If BOOTP or DHCP address resolution mode is selected, you cannot change the IP address,
Subnet Mask, or default gateway. If RARP address resolution mode is selected, you cannot change
the IP address. Select [Static] if you wish to disable dynamic addressing.
f. Enter details of an identifier of the IP site in which the device is connected in the [Domain
Name] field.
g. If DNS configuration is required, enter IP address for the [Primary DNS Server]. Enter an IP
address for [Alternate DNS Servers 1] and [Alternate DNS Servers 2].
Note: If DHCP or BOOTP is the IP Address Resolution setting, you cannot change the Domain
Name, Primary DNS Server, Alternate DNS Server 1, and Alternate DNS Server 2 settings.
84 Xerox ColorQube™ 9201/9202/9203
System Administrator Guide
Enable TCP/IP and HTTP at