Sip Settings - Nortel BCM50 Configuration Manual

SIP Settings

Figure 32 SIP Settings tab
Table 24 SIP Settings fields
Field
Telephony Settings
Fallback to circuit-switched
SIP Settings
Domain Name
Call signaling port
Outgoing Transport
Proxy Support
Proxy
Status
Value Description
Enabled-All Your choice determines how the system will handle calls if the
IP network cannot be used.
Enabled-TDM
•
Disabled
•
•
Default: Enabled-All
Domain of the SIP network.
This is the listening port for the BCM
Note: FEPS (Functional Endpoint Proxy Server) must be
restarted if this values is changed.
Default: 5060
UDP The outgoing transport protocol for the gateway.
Note: UDP is the only transport supported by the SIP enabled
data services.
Default: UDP
<IP address> Specify the IP address of the SIP proxy server.
<read-only> Indicates the status of the gateway.
Chapter 9 Configuring telephony resources
Enabled-All: All calls will be rerouted over specified PSTN
trunks lines.
Enabled-TDM: All TDM (digital telephones) voice calls will
be rerouted over specified PSTN trunks lines.
Disabled: Calls will not be rerouted.
Networking Configuration Guide
125