Call Security: Remote Access Packages; Configuring Remote Access Packages - Nortel BCM50 Configuration Manual

Chapter 55

Call security: Remote access packages

This panel describes the telephony configuration that is used to control access to system lines by
calls coming in from outside the system.The remote access package also allows remote paging
capabilities.
Note: Callers dialing into the system over private network lines are also
considered remote callers.
The following paths indicate where to access remote access packages in Element Manager and
through Telset Administration:
• Element Manager: Configuration > Telephony > Call Security > Remote Access Packages
• Telset interface: **CONFIG > System prgrming > Remote Access
This is a two-table panel, where you select a Remote Access Package number on the first panel
and then add or delete the line pools from the second table.
Panels/Subpanels
"Configuring remote access packages" on
page 439
Also refer to:
Click the navigation tree heading to access general information about Hospitality services.

Configuring remote access packages

Use these panels to add allowed line pools to up to 99 remote access packages.
Remote access packages are assigned to lines and class of service (CoS) passwords. Lines used for
private networking need remote access packages because calls coming from other nodes on the
network are considered remote call-ins by your system.
Tasks
"Restrictions (Line and Remote)" on page 137
"Call Security: Configuring Direct Inward System
Access (DISA)" on page 427
"Configuring CoS passwords for remote access" on
page 443
(lines)
Networking Configuration Guide
439