To Configure The Isdn Link Parameters - Nortel BCM50 Configuration Manual

Table 111 ISDN Dial-out Interface Link Parameters fields (Sheet 2 of 2)
Attribute
IP Header
Compression
Software Compression <check box>
Access Settings
Authentication
Dial-Out User Name

To configure the ISDN Link Parameters

1
Click Configuration > Resources > Dial Up Interfaces.
2 Click the ISDN interface to configure.
3 Click the Link Parameters tab.
The Link Parameters panel appears. See
4 Configure the ISDN Link Parameters. Refer to the information in
Value
<check box>
PAP or CHAP
<drop-down list>
Chapter 70 Dial Up Interfaces panel
Description
Enable or disable IP header compression.
Note: The feature must be enabled at both ends of the
connection.
Default: enabled
Enable or disable software compression. When
enabled, all dial-up connections use BSD Scheme for
compression.
Default: disabled
Select the authentication type for the link.
Default: CHAP
Enter the username used for authenticating to the
remote end.
Figure 138.
Table 111.
Networking Configuration Guide
507