To Add Or Modify A Cos Password - Nortel BCM50 Configuration Manual

• "External access tones" on page 447
Note: You can add a maximum of 99 CoS Passwords.

To add or modify a CoS password

1
On the Class of Service table, click the CoS line to which you want to add or modify a
password.
2
Select the field you want to change and enter the appropriate information:
• Name: Enter a descriptive name for the password or user
• Password: Enter a set of six digits that are unique from any other CoS password
• Set Restriction Filter: If you want the user to be able to override set and line/set
restrictions for the number being called, enter the allowed filters.
• Line Restriction Filter: If you want the user to be able to override the line restrictions that
the call uses to access the system, enter the allowed filters here.
• Remote Package: Enter the remote package that you want the system to use to determine
the level of access the user will have to system features.
Notes about CoS passwords
The CoS password can define the set of line pools that may be accessed and whether or not the
user has access to the paging feature. The password all defines which restrictions are applied.
The class of service (CoS) that applies to an incoming remote access call is determined by:
• The filters that you apply to the incoming trunk.
• The CoS password that the caller used to gain access to BCM.
• In cases where DISA is not automatically applied to incoming calls, the remote caller can
change the class of service by dialing the DISA DN and entering a CoS password.
Chapter 56 Configuring CoS passwords for remote access
Networking Configuration Guide
445