Switches Supporting Call-By-Call Limits - Nortel BCM50 Configuration Manual

Switches supporting Call-by-call limits

Table 40 lists the service types and cross-references them with four common switches.
Table 40 Switches and service types chart
Switches
Service types 1 NI-2
FX FX
Tie TIE
3
INWATS INWATS
International Same as INWATS
INWATS
OUTWATS IntraLATA
OUTWATS
OUTWATS with
bands
InterLATA
OUTWATS
Private
Switched Digital N/A
Nine Hundred N/A
Public Public
1. N/A indicates that the protocol does not support the service.
2. DMS-250 Sprint and UCS support incoming FX only (that is, Network-to-BCM).
DMS-250 MCI does not support FX.
3. NI-2 allows two TIE operating modes: senderized and cut-through. BCM supports only senderized mode.
4. Rates greater than 64 kbps are not supported.
5. Bell Canada VNET.
6. Not all service types may be supported by a switch type. For information, contact your service provider.
DMS-100 DMS-250
(custom)
FX N/A
2
TIE TIE
INWATS Eight Hundred
Same as Same as
INWATS INWATS
OUTWATS PRISM
DMS Private 5 VNET (virtual
network)
N/A N/A
N/A Nine Hundred
Public Public
Chapter 24 Dialing plans
AT&T 4ESS
N/A
SDN (software defined
network)
Toll Free MEGACOM
International Toll Free
Service
MEGACOM
N/A
ACCUNET 4
MultiQuest
N/A
Networking Configuration Guide
237