Nortel BCM50 Configuration Manual page 515

Figure 143 Modem Dial-In Parameters panel
Table 116 Modem Dial-In Parameters fields (Sheet 1 of 3)
Attribute
Enable Modem Dial-In
Allow network access
Connection State: This is a table that shows the current dial in state if connected.
Note: There is a maximum of one entry in this table (as there is only one modem). This table will be blank
if no dial in connection is currently active.
Value Description
<check box> Enable or disable modem dial-in.
Default: disabled
<check box> Enable or disable dial-in access to the entire network.
Default: disabled
Chapter 70 Dial Up Interfaces panel
Networking Configuration Guide
515