Option Settings - Nortel Meridian 1 Installation Manual

Option settings

Content list
Reference list
Circuit card grid
The following are the topics in this section:
• Reference list 31
• Circuit card grid 31
• General purpose switches 34
• Trunk interface switches 34
• Ring ground switches 36
• DCH mode and address select switches 36
• Illustrations of switch locations and settings 38
The following are the references in this section:
• Multi-Purpose Serial Data Link: Description (553-3001-195)
• X11 Administration (553-3001-311)
Some circuit cards contain option switches or jumpers, or both, that define
specific functions. A switch or jumper can be identified by an alphanumeric
coordinate (such as D29) that indicates a location on the card, or by a switch
number (such as SW2) printed on the circuit board (see Figure 3). Positions
on a switch (for example, positions 1, 2, 3, and 4 on SW2) are labeled on the
switch block.
Circuit Card Installation and Testing
Page 31 of 74