Configuring Cos Passwords For Remote Access; Class Of Service Table - Nortel BCM50 Configuration Manual

Chapter 56

Configuring CoS passwords for remote access

The Class of Service panel allows you to configure passwords for system users who will be dialing
into the system over a PSTN/private network to use system features, or for users who must bypass
local restrictions on telephones.
The following paths indicate where to access the Class of Service settings in Element Manager and
through Telset Administration:
• Element Manager: Configuration > Telephony > Call Security > Class of Service
• Telset interface: **CONFIG > Passwords
Click one of the following links to connect with the type of information you want to view:
Panel tabs
"Class of Service table" on page 443
Also refer to:
Click the navigation tree heading to access general information about user management.
CoS passwords permit controlled access to the system resources by both internal and remote users.
• When an internal user enters a CoS password at a telephone, the restriction filters associated
with the CoS password apply instead of the normal restriction filters.
• Similarly, when a remote user enters a CoS password on an incoming auto-answer line, the
restriction filters and remote package associated with their CoS password apply instead of the
normal restriction filters and remote package.

Class of Service table

Refer to the following CoS information:
• "Notes about CoS passwords" on page 445
• "External access tones" on page 447
Security Note: Change passwords frequently to discourage unauthorized access.
!
Tasks/Features
"External access tones" on page 447
"Call security: Restriction filters" on page 433
"Call Security: Configuring Direct Inward System
Access (DISA)" on page 427
"Call security: Remote access packages" on
page 439
Networking Configuration Guide
443