Nortel BCM50 Configuration Manual page 103

The Telephony Resources table fields are described in
Table 13 Telephony Resources table fields (Sheet 1 of 2)
Attribute
Location
Module type
Bus
State
Devices
Low
High
Total
Value Description
<read-only>
<read-only> This field indicates the type of module assigned to each
location.
DID4
DID4
DID8
DID8
ASM/ASM+
ASM/GASM: Analog and Global Analog Station Modules
GATM4
provide four connections for four analog telephones.
DSM16
GATM8: Global Analog Trunk Module with four trunk line
DSM32/
connections.
DSM32+
DSM16 or DSM32/DSM32+: Digital Station Module with 16
4X16 Combo
and 32 telephone connections, respectively.
8X16 Combo
4X16 Combo: A module with 4 analog trunks and 16 digital
DTM-T1
stations.
DTM-PRI
8X16 Combo: A module with 8 analog trunks and 16 digital
stations.
CTM4/GATM4
BRI-ST
CTM8/GATM8
DTM-T1
BRIM
DTM-PRI
Empty
Empty: No module is currently connected.
<read-only> This number indicates the virtual bus to which the module is
assigned. For trunk modules, this position determines the
1-XX
default line numbers available to the trunks attached to the
module.
For station modules, this position determines the DN range
that will automatically be assigned to telephones plugged
into the module.
Enabled Indicates the state of the module or bus:
Disabled Enabled: module is installed and working
Unequipped Disabled: module is installed but has been disabled or is
down for another reason
Unequipped: there is no module installed on this bus
Set Lists the type of device configured on the bus.
Lines
<digits> This field indicates the lowest setting for one of the following:
The range of lines the module/VoIP supports
The range of loops the module supports (BRI)
The range of DNs the module/IP telephony supports.
<digits> This field indicates the highest setting for one of the
following:
The range of lines the module/VoIP supports
The range of loops the module supports (BRI)
The range of DNs the module/IP telephony supports.
<XX> Lines, This field indicates the total number of lines, loops or DNs
loops or Sets that the module supports.
Chapter 9 Configuring telephony resources
Table 13.
Networking Configuration Guide
103