Nortel BCM50 Configuration Manual page 440

440 Chapter 55 Call security: Remote access packages
Figure 126 Remote Access Packages tables
Table 91 describes each field on this panel.
Table 91 Remote Access Packages (Sheet 1 of 2)
Attribute Values
Packages table
Package <00-99>
Remote Page <check box>
Line Pool Access table
Line pool <A to O>/BlocA to F
(PRI and VoIP)
Actions
Add (line pool) Package 00 is the default package and cannot be deleted. It provides no access to
any line pools.
1. On the Packages table, select the remote package number that you want to
2. Under the Line Pool Access table, click Add.
3. In the Add dialog, enter a line pool.
4. Click OK to save the pool.
5. Next steps: Add remote access packages to lines and CoS passwords.
NN40020-603 NN40020-603
Description
This designates the package number. This is what is entered
in the fields for lines programming for remote access.
Select check box if you wish to allow remote callers access
to paging.
Note: Remote paging is not supported on IP trunks.
Choose the line pool for which you want this package to be
available.
configure.