Unpacking The Expansion Unit; Verifying The Media Bay Module Switch Settings - Nortel BCM50 3.0 Installation And Maintenance Manual

96 Chapter 8 Installing an expansion unit
For information about installing an expansion unit:
•

Unpacking the expansion unit

•

Verifying the media bay module switch settings

• Installing a media bay module in an expansion unit
• Installing the expansion unit
Unpacking the expansion unit
Open the expansion unit box and remove all the components. Check that the box contains the
following components:
• one expansion unit
• one expansion unit power supply
• one power supply cable
• one expansion cable (shielded Ethernet cable)
• one power supply retention clip
• four rubber feet
Visually inspect the components for damage during shipping. If you find damage, contact your
Nortel representative.
Warning: Make sure the power supply to the expansion unit is disconnected
before inserting or removing an MBM.
Verifying the media bay module switch settings
Each MBM has dip switches on the back or underside of the module. See the figure
the media bay module (not applicable for GASM or GATM)
NN40020-302
on page 96
on page 96
on page 101
on page 100
on page 97.
Switches on