Nortel BCM50 Configuration Manual page 135

Table 29 defines the fields on this panel and indicates the lines.
Table 29 Preferences details fields for lines (Sheet 1 of 3)
Attribute Value
Legend: Loop = analog/digital loop; GS = ground start; DID = DID; E&M = E&M; BRI = BRI; DPNSS
= DPNSS; VoIP = VoIP; TL = Target and DASS2. Note: PRI fields are all included under the main
panel.
Auto privacy Loop
<check box>
Full autohold Loop
<check box>
Aux. ringer Loop
<check box>
Note: When programmed only on a telephone, no ring occurs for a transferred call.
An auxiliary ringer can also be programmed in Services to ring for a line placed into
a scheduled Ringing service. Refer to "Configuring scheduled service" in the Device
Configuration Guide (NN40020-300).
ANI Number
<check box>
DNIS Number
<check box>
Distinct Rings in <read-only>
use
Description
GS DID E&M
Define whether one BCM user can select a line in use at
another telephone to join an existing call. Refer to "Turn Privacy
on or off" in the Device Configuration Guide (NN40020-300)
(FEATURE 83).
Enables or disables Full autohold.
When enabled, if a caller selects an idle line but does not dial
any digits, that line is automatically placed on hold if you then
select another line.
Full autohold is always in place for T1 E&M trunks because it
has no meaning for incoming-only T1 DID trunks.
The default setting should be changed only if Full autohold is
required for a specific application.
GS DID E&M
Turn the auxiliary ringer on or off for all telephones using this
line.
When programmed on a line, the auxiliary ringer will ring every
time a call is received.
DID E&M
Define whether the telephone number of the caller will be
shown for this line.
For T1 E&M and T1 DID trunks connected to a DTM, this setting
only appears if Signaling is set to WinkStart.
The central office must deliver ANI/DNIS in DTMF mode. No
additional equipment is required.
E&M
Defines whether the digits dialed by an external caller on this
line will be shown.For T1 E&M trunks connected to a DTM, this
setting only appears if Signaling is set to WinkStart and Answer
mode is set to Manual.
Indicates if a special ring has been assigned. See Distinct Ring
on the main table.
Chapter 10 Configuring lines
BRI VoIP
BRI DPNSS VoIP
BRI DPNSS VoIP
Networking Configuration Guide
135
TL