Additional Configuration To Allow Network Access Functionality - Nortel BCM50 Configuration Manual

Table 116 Modem Dial-In Parameters fields (Sheet 3 of 3)
Attribute
Auto-disable timer
Directory Number
Local IP Address Specification
Remote assigned
IP Address
Remote IP Address Specification
Assign IP address to
remote
IP Address

Additional configuration to allow network access functionality

If the BCM50 has an integrated router (BCM50a or BCM50e), then you must:
• Configure a static route on the integrated router.
• Configure the firewall on the integrated router to Bypass Triangle Route.
For example, consider the network configuration shown in
Figure 144 Typical dial-in configuration
PC1
(192.168.1.50)
Value Description
<0-30 Time after which the Dial-in for the modem is disabled after
minutes> use.
Default: 0
<read-only> Read-only number assigned to the analog modem. Used for
manual transfer of call or by auto-attendant.
<check box> If selected, the BCM obtains its IP address from the remote
end.
Default: disabled
<IP Address> Use this IP Address as the local IP address for the PPP
connection. This value is used when "Remote assigned" is
disabled.
Default: 10.10.14.1
<check box> If selected, the BCM will assign the IP address specified in the
IP Address field of this section to the remote end of the
connection.
Default: selected
<IP Address> When the Assign IP address to remote is enabled BCM will
assign to the remote end of the connection the IP address
specified in this field.
Default: 10.10.14.2
Customer LAN
Chapter 70 Dial Up Interfaces panel
Figure 144.
BCM50a/e
CSC: 192.168.1.2
Router: 192.168.1.1
Networking Configuration Guide
517
DIALIN_PC
(10.10.14.2)