Module Configuration: Trunk Modules - Nortel BCM50 Configuration Manual

Chapter 6

Module configuration: Trunk modules

This following describes the Element Manager headings that define and control the settings for the
trunk media bay modules installed on your system.
The following paths indicate where to access the trunk modules in Element Manager and through
Telset Administration:
• Element Manager: Configuration > Resources > Telephony Resources
• Telset interface: **CONFIG > Hardware
For an overview of the Telephony Resources panel, refer to
page 101.
Task: To confirm settings for the trunk media bay modules installed in the system.
• Confirm that all prerequisites are complete. Refer to
parameters" on page
• Confirm or set module parameters as follows:
•
•
• Provision modules and confirm auto-entry information. Refer to
module lines/loops" on page
Prerequisites
Complete the following prerequisites checklist before configuring the modules.
System hardware is installed and operating correctly.
All relevant central office/service provider information for the trunk type
has been obtained.
Keycodes have been activated for core module trunks.
Expansion modules are installed and operating, and LEDs are correct.
83.
If your module supports T1, PRI, or DASS2, refer to
Selection" on page 108
For other types of trunk modules, configure each line record. Refer to
"Configuring lines" on page
"Configuring telephony resources" on
and "Provisioning module lines/loops" on page
129.
112.
"Configuring the trunk module
"Call-by-Call Service
"Provisioning
Networking Configuration Guide
81
112.