Nortel BCM50 Configuration Manual page 173

4 Set the restriction and remote package scheduling (Restrictions tab):
• Line restrictions: Enter a valid restriction filter for the Normal schedule, and any other
schedules that you want this line to be part of. (outgoing calls)
• Remote Restrictions: Enter a valid remote access package for the Normal schedule, and
any other schedules that you want this line to be part of (incoming calls from remote users
or private networks)
5 Assign the lines to DNs (Assigned DNs tab) (applicable to manual answer only)
If you have configured the DNs and know to which telephones the line needs to be assigned,
you can enter those DNs, here. The DN record also can be used to assign lines and line pools
for these lines.
• Appearance type: Choose Appear or Appear and ring if the telephone has an available
button, otherwise choose Ring Only. Model 7000 and 7100 telephones have no
programmable buttons, so this must be set to Ring only. (Model 7000 phones, supported in
Europe only.)
• VMsg set: When activated, an indicator on the telephone appears when a message from a
remote voice-mail system is waiting.
Check with your system administrator for the system voice mail setup before changing
this parameter.
6 Suggested next steps:
• Dialing plan
"Dialing plan: System settings" on page 267
"Dialing plan: Public network" on page 275
"Dialing plan: Routing and destination codes" on page 259
• Networking
"Public networking: Setting up basic systems" on page 289
"Public networking: Tandem calls from private node" on page 293
"Private networking: Using destination codes" on page 339
Chapter 16 Configuring lines: T1-DID
Networking Configuration Guide
173