To Activate The Voip Line From The Control Set; To Deactivate A Schedule; Deactivating The Voip Schedule; Example: A Private Network Configured For Fallback - Nortel BCM50 Configuration Manual

396 Chapter 46 Setting up VoIP trunks for fallback

To activate the VoIP line from the control set

1 Dial FEATURE 873 from the control set for the VoIP trunk.
The phone prompts you for a password.
2 Type the password (default - admin: 23646).
3 Press OK.
The first schedule appears.
4 Scroll down the list until VoIP is selected.
5 Press OK.
The VoIP schedule stays active, even after a system reboot, and can only be manually
deactivated.

Deactivating the VoIP schedule

To deactivate a schedule

1 Dial FEATURE #873. The phone prompts you for a password.
2 Type the password.
3 Press OK. The system returns to the Normal schedule.

Example: A private network configured for fallback

The following describes a sample BCM configuration, which includes:
• "Activating the VoIP schedule for fallback" on page 395
• "Deactivating the VoIP schedule" on page 396
In this scenario, shown in
One BCM is in Ottawa, the other is in Santa Clara. Both VoIP trunks and an PRI SL-1 line connect
the system in a private network.
NN40020-603 NN40020-603
Figure 117, two BCMs in different cities are connected through a WAN.