Mcdn Networking Checklist - Nortel BCM50 Configuration Manual

MCDN networking checklist

The following points provide a quick check for the system prerequisite settings for MCDN
networking.
Select the dialing plan to be used:
• UDP (Universal Dialing Plan)
— DNs on the same node are dialed directly.
— DNs on other nodes are called by first dialing an Access Code and an ESN.
— Each node has its own ESN.
• CDP (Coordinated Dialing Plan)
— DNs on all nodes are dialed directly.
Ensure the following common programming is configured:
• BCM Programming
— Configure the system DN length to match the DN length used in the rest of the private
network.
— Program the private Route: Type=Private, Dial=None.
— Program the public Route: Type=Public, Dial=None.
— Enable the MCDN Supplementary Services; TRO=selected, ICCL=selected,
TAT=selected.
— Program telephones with a target line that specifies the system DN of the telephone in the
Private received number field.
Note: If you have public DNs set up for your telephones that are
different from the system-assigned DN, each telephone needs to use the
public and private received digits on the target line.
• Meridian 1 Programming
— Program the system PNI and the PNIs for the routes.
— Program the Meridian voice mailboxes (if required).
— Enable the MCDN Supplementary Services: RCAP=[ND2,TRO,MWI], NASA=YES.
Set up the specific programming the system requires for the dialing plan. Refer to the following
tables.
Chapter 32 Private networking: MCDN over PRI and VoIP
Networking Configuration Guide
303