To Assign A Modem Interface For Wan Failover; To Assign An Isdn Interface For Wan Failover; Modem Dial-In Parameters Panel - Nortel BCM50 Configuration Manual

514 Chapter 70 Dial Up Interfaces panel
Caution: Router Settings
The following settings must be configured on the router for WAN failover to
function:
Port Speed - 115200
Enable Dial Back-Up check box - selected
Do not change any other Basic or Advanced router settings.
Note: The WAN failover feature operates only on BCM50a, BCM50e,
BCM50ba, or BCM50be Release 2.

To assign a modem interface for WAN failover

1
Create, and enable, a modem interface. See
2 Click Configuration > Resources > Dial Up Interfaces > Global Settings.
3 From the Failover interface drop-down list, select the interface to configure as a WAN
backup.

To assign an ISDN interface for WAN failover

1 Create, and enable, an ISDN interface. See
2 Click Configuration > Resources > Dial Up Interfaces > Global Settings.
3
From the Failover interface drop-down list, select the interface to configure as a WAN
backup.
4 Click Add on the ISDN Dial-Out Line Pool Access subpanel.
The Add Line Pool dialog box appears.
5 Enter a line pool the ISDN interface can use to dial out.
6 Click OK.

Modem Dial-In Parameters panel

The Modem Dial-In parameters controls Dial-in to the BCM for remote access. This panel is used
to configure the modem for Dial-in. It also displays the connection status of the modem if one is in
progress. The Modem Dial-in Parameters panel is shown in
integrated router (BCM50a or BCM50e), see
functionality" on page
NN40020-603 NN40020-603
"Additional configuration to allow network access
517.
"To add the modem interface" on page
"To add an ISDN interface" on page
Figure 143. If the BCM50 has an
508.
503.