Figure 142 Global Settings panel
Table 115 Global Settings field
Attribute
Automatic WAN Failover
Failover interface
ISDN Dial-Out Line
Pool Access
WAN failover
The Integrated Router monitors the status of the primary WAN link. When the primary WAN link
is detected to have failed, the Integrated Router will route the traffic to the WAN Failover dial-up
interface, if one is configured. Refer to
Value
Description
<drop-down list>
Select one of the existing dial-out interfaces that is not
selected for "Automatic dialout". Dial-out interfaces are
provisioned from the Dial-out Interfaces tab in this same
section.
Default: -None-
Note: This parameter will not be displayed if the particular
BCM does not have the hardware to provide Failover
support.
Assign a Line Pool for ISDN dial out.
Chapter 70 Dial Up Interfaces panel
"WAN Failover Service" on page
500.
Networking Configuration Guide
513