Udp-Specific Programming - Nortel BCM50 Configuration Manual

304 Chapter 32 Private networking: MCDN over PRI and VoIP

UDP-specific programming

BCM UDP programming
• Private Dialing Plan:
• Private Access Code
• Private DN length
• Program the DestCodes for
the other nodes
M1 UDP programming
• Private Access Code
• Check UDP programming
• Program UDP values to
route
NN40020-603 NN40020-603
Type=UDP, HomeLoc=<three-digit prefix>
<unique code>
<total of Private Access Code + Location Code + DN length>
Example: if dialing string is 6 393 2222, then set private DN to 8
AccessCode plus the ESN, absorb the AccessCode.
Example: For AccessCode=6; DestCode=6393[Absorb=1]
Overlay 86, LD 86
REQ: PRT
CUST: 0
FEAT: ESN
Overlay 90, LD 90
REQ: PRT
CUST: 0
FEAT: NET
TYPE: LOC
LOC: press enter, all the programmed location codes are listed
HLOC is the home location of the M1
Overlay 90, LD 90
REQ: CHG
CUST: 0
FEAT: NET
TYPE: AC1
LOC: (enter a number)
RLI: (enter the RLI corresponding to the route)
To change Private Access
Code:
Overlay 86, LD 86
REQ: CHG
CUST: 0
FEAT: ESN, keep pressing
until you reach the AC1 prompt
At the AC1 prompt, make your
choice