Configuring Voip Line Features - Nortel BCM50 Configuration Manual

386 Chapter 44 Configuring VoIP trunk gateways
You must also set up target lines when you use these trunks.
The following path indicates where to set up target lines in Element Manager:
• Element Manager: Configuration > Telephony > Lines > Target Lines
Prerequisites
Complete the following prerequisites checklist before configuring the modules.
The gateway and IP network is set up correctly. Refer to the following
procedures:
• "Configuring VoIP trunk media parameters" on page 382
• "Setting up the local gateway" on page 383
• "Setting up remote gateways" on page 385
• "VoIP interoperability: Gatekeeper configuration" on page 389
Obtain all relevant central office/service provider information for the type
of trunk.

Configuring VoIP line features

The following procedure describes the fields that need to be confirmed or set for these lines. For
detailed field descriptions, refer to
1 Confirm or change the settings on the Line/Trunk main panel:
• Line: Unique number
• Trunk type: VoIP
• Name: identify the line or line function
• Control Set: identify a DN if you are using this line with scheduling.
• Line Type: define how the line will be used. If you are using routing, ensure it is put into
Bloc (A to F)
• Prime Set: If you want the line to be answered at another telephone if the line is not
answered at the target telephone, otherwise, choose None.
• Pub. Received #: Not applicable
• Priv. Received #: Not applicable
• Distinct Ring: If you want this line to have a special ring, indicate a pattern (2, 3, 4, or
None).
2 Configure the trunk/line data:
In the top panel ensure a loop trunk is selected. In the bottom panel, select the Preferences tab.
• Aux. ringer: If your system is equipped with an external ringer, you can enable this setting
to allow this line to ring at the external ringer.
3
On the bottom panel, under the Restrictions tab:
• Use remote package: If this line is used for remote call-ins or is part of a private network,
ensure you specify a valid remote package.
NN40020-603 NN40020-603
"Configuring lines" on page 129.