Configuring Lines: T1-E&M - Nortel BCM50 Configuration Manual

Chapter 13
Configuring lines: T1-E&M
E&M lines must be digital (T1).
The following paths indicate where to access the E&M lines in Element Manager and through
Telset Administration:
• Element Manager: Configuration > Telephony > Lines
• Telset interface: **CONFIG > Lines
Task: Configure T1 E&M lines connected to the system
• "Configuring E&M line features" on page 155
Prerequisites
Complete the following prerequisites checklist before configuring the modules.
DTM module: Installed and configured. Refer to
Parameters" on page
Lines are provisioned. Refer to
page 112.
Process map
Figure 44, Figure
T1-E&M lines.
104.
"Provisioning module lines/loops" on
45, and Figure 46 provide an overview for configuring the line features for
"Trunk Module
Networking Configuration Guide
151