Isdn Interfaces - Nortel BCM50 Configuration Manual

502 Chapter 70 Dial Up Interfaces panel
Figure 136 Dial-out Interfaces panel
Table 109 Dial-out Interfaces fields
Attribute
Type
Interface Name
Automatic dialout
Protocol
Enable
Status
IP Address
Subnet Mask

ISDN interfaces

ISDN interfaces can only be configured on a BCM50 with an integrated BRI module, or on a BCM
with a BRI MBM installed in the expansion unit. A maximum of two BRI-ISDN interfaces are
supported on each BCM. Each of these interfaces supports two ISDN B-channels.
NN40020-603 NN40020-603
Value
<drop-down list>
<alphanumeric string>
<check box>
<read-only>
<check box>
<read-only>
<read-only>
<read-only>
Description
Select the type of interface to be added. Interface
types supported: Modem, ISDN
Enter a logical name to identify the interface.
Enable or disable the interface for Automatic dialout.
Selected: static routes can be added for this interface.
Cleared: this interface can be used for WAN Failover.
Note: Automatic dial-out interfaces can not be used
for WAN failover.
Always PPP.
Enable or disable the interface.
Current connection status: Disconnected,
Connecting, Connected.
IP address assigned to the connected interface.
Subnet mask assigned to the connected interface.