Chapter 20
BRI ISDN: BRI T-loops
BRI modules support both trunk and station (telephone) services.
The following describes the process for configuring trunk (T) loops.
Task: Configure BRI T-loops
Configuring BRI T-loop parameters
Prerequisites
Complete the following prerequisites checklist before configuring the modules.
Ensure that system hardware is installed and operating correctly.
Obtain all relevant central office/service provider information for the
loops.
BRI module is installed and operating (LEDs are correct).
Process overview
Figure 63
shows the process for configuring BRI loops.
on page 197
Networking Configuration Guide
195