The Internal LAN is an interface that is used internally by the BCM for digital signal processing.
Warning: Only modify a subnet if the address the subnets are currently set to are in-use
elsewhere on the network.
Modifying a Subnet
Warning: You should modify a subnet only if the address the subnet is currently set to are
in use elsewhere on the network.
To modify a subnet
1
Click Configuration > System > IP Subsystem > Internal Subnets tab.
2
Select the Subnet to modify.
3
Click Modify.
The Modify Internal Subnet Settings dialog box appears.
4
Change the settings.
5
Click OK.
Internal Subnet Details
The Internal Subnet Details panel contains a table showing the OAM LAN Subnet Details. The
details panel displays the DHCP lease of any PC that connects to the OAM port. This table is
read-only.
Chapter 60 IP Subsystem
Networking Configuration Guide
459