Nortel BCM50 Configuration Manual page 184

184 Chapter 18 Configuring lines: DPNSS lines
• Prime Set: If you want the line to be answered at another telephone if the line is not
answered at the target telephone, otherwise, choose None.
• Pub. Received #: Not applicable.
• Priv. Received #: Not applicable.
• Distinct ring: If you want this line to have a special ring, indicate a pattern (2, 3, 4 or
None).
• Use remote package: If this line is used for remote call-ins or is part of a private network,
ensure you specify a valid package.
2 Configure the trunk/line data (Properties tab):
• Answer mode: If this line is used for remote call-ins, determine how you want the line to
answer (automatically, or requiring more user input).
• Use auxiliary ringer: If your system is equipped with an external ringer, you can enable
this setting to allow this line to ring at the external ringer.
• Full autohold: This allows telephones to put a line on hold if the user picks up another line
or starts to dial out on another line.
• Voice Message Center: If the system is using a remote voice mail, select the center
configured with the contact number.
3 Set the restriction and remote package scheduling (Restrictions tab):
• Line restrictions: Enter a valid restriction filter for the Normal schedule, and any other
schedules that you want this line to be part of. (outgoing calls)
• Remote Packages: Enter a valid remote access package for the Normal schedule, and any
other schedules that you want this line to be part of (incoming calls from remote users or
private networks)
4 Assign the lines to DNs (Assigned DNs tab)
If you have configured the DNs and know to which telephones the line needs to be assigned,
you can enter those DNs, here. The DN record also can be used to assign lines and line pools
for these lines.
• Appearance type: Choose Appr or Appr&ring if the telephone has an available button,
otherwise choose Ring only. Model 7000 and 7100 telephones have no programmable
buttons, so this must be set to Ring only. (Model 7000 phones, supported in Europe only.)
• VMsg set: When activated, an indicator on the telephone appears when a message from a
remote voice-mail system is waiting. Check with your system administrator for the system
voice mail setup before changing this parameter.
5
Suggested next steps:
• Dialing plan
"Dialing plan: System settings" on page 267
"Dialing plan: Public network" on page 275
"Dialing plan: Private network settings" on page 281
"Dialing plan: Routing and destination codes" on page 259
NN40020-603 NN40020-603