Nortel BCM50 Configuration Manual page 516

516 Chapter 70 Dial Up Interfaces panel
Table 116 Modem Dial-In Parameters fields (Sheet 2 of 3)
Attribute
User
Local IP Address
Remote IP Address
Callback
Status
Callback Settings
Callback retries
Callback retry
interval (s)
PPP Configuration. These parameters are passed to PPP stack to manage the PPP connection.
Idle timeout
Maximum Receive Unit <128–1500>
Maximum Transmit Unit <128–1500>
Authentication support
Dial-In Settings
Line
Calling Number
Number of Rings
Auto-disable
NN40020-603 NN40020-603
Value Description
<read-only> Displays the user that is currently dialed in.
<read-only> The local IP address assigned to the dial-in connection.
<read-only> The remote IP address of the dial-in connection.
<read-only> Displays if callback is enabled for this dial-in connection.
<read-only> The status of the dial-in connection.
<1-10> The number of attempts made by the BCM to dial-out to the
remote end during callback.
Default: 3
<0-360> Interval for successive connection attempts for dial-out during
callback.
Default: 60 seconds
<numeric Idle time after which, PPP will terminate the PPP connection.
string>
Default: 1800 seconds
The maximum size of the packets that can be received.
Default: 500
The maximum size of the packets that can be sent.
Default: 500
PAP Supported PPP authentication
CHAP Default: CHAP
MSCHAP
MSCHAPv2
<numeric Line number monitored by the modem for incoming calls. A
string> value of 0 = blank. Range: Min Target Line-Max Target Line
Default: blank
<numeric Analog modem uses this Calling Number (Calling ID – CLID)
string> to detect an incoming data call.
<1-10> Number of rings before the BCM redirects a call to the
modem. This field applies only when a call is directed to the
line number specified in this section. Otherwise, this value is
ignored and the modem answers 10 seconds after a call is
presented.
Note: The number of rings, for certain market profiles, must be
multiplied by 2 due to double ring cadence. For these profiles,
the maximum number of rings is 5. (5x2=10)
Default: 1
<check box> When selected, the modem is automatically disabled after
use.
Default: disabled