Creating An Automatic Dial-Out Interface - Nortel BCM50 Configuration Manual

Table 118 ISDN Dial-In Parameters fields (Sheet 3 of 3)
Attribute
Second dial-in IP
Address
Remote IP Address Specification
Assign IP address to
remote
First dial-in IP Address
Second dial-in IP
Address

Creating an automatic dial-out interface

Caution: Select the Enable Dial Back-Up check box to enable Dial Back-up on
the router. Do not change the other Basic or Advanced Settings.
Management applications such as SNMP trap dial out, Scheduled Log transfer, Scheduled Backup,
and Scheduled CDR records transfer can use automatic dial-out over an ISDN or Modem
interface. To configure the automatic data transfer, the administrator must configure a static route,
with the auto dial-out field selected, and associate it with the application. When data is sent to the
destination address, the network recognizes the address of the application, and triggers the dial-out
to establish the connection.The packets are then sent over the link to the destination.
Notes:
• The dial-out interface must be enabled to configure static routes.
• The disconnect time for the interface must be greater than 60 seconds. This is configured on
the Link Parameters tab of the selected interface under Configuration > Resources > Dial
Up Interfaces.
• Auto dial-out routes cannot be added if the interface is already manually connected, unless the
interface is already connected with auto dial-out routes configured.
Value Description
<IP Address> The IP address that will be assigned to the BCM side of the
second dial-in connection. This is only assigned if Remote
Assigned is disabled.
Default: 10.10.18.2
<check box> When enabled, BCM will assign the remote end of the
connection one of the IP addresses specified below.
When cleared, the remote side will assign it's own IP address.
Default: enabled
<IP Address> The IP address that will be assigned to the remote side of the
first dial-in connection. This is only assigned if Assign IP
address to remote is enabled.
Default: 10.10.18.10
<IP Address> The IP address that will be assigned to the remote side of the
second dial-in connection. This is only assigned if Assign IP
address to remote is enabled.
Default: 10.10.18.11
Chapter 70 Dial Up Interfaces panel
Networking Configuration Guide
521