Transmitting Ip Line Node Configuration Data - Nortel Meridian 1 Succession 1000M Installation And Configuration Manual

Page 328 of 562
Figure 124
OTM 2.1 primary and secondary IP addresses

Transmitting IP Line node configuration data

553-3011-210 Standard 1.00
IP Line card configuration
IP Line node and card properties are configured in the OTM IP Line IP
Phones application and then transmitted to the IP Line cards. OTM converts
the configuration data to text files and transmits files to the line cards. Refer
to IP Line: Description, Installation and Operation (553-3001-365) and
Telephones and Consoles (553-3001-367). Complete the following steps:
1 Set the Leader 0 IP address from TTY connected to local RS232
maintenance port.
2 Transmit the node and card properties from OTM IP Line IP Phones
application to Leader 0.
3 Transmit card properties to all cards in the node.
October 2003