Set Check-In, Check-Out Parameters - Nortel Meridian 1 Manual

Page 66 of 120 Room Status

Set check-in, check-out parameters

553-2311-316 Standard 10.00
Options you can set allow the check-in and check-out commands to perform
a number of operations automatically.
The following options are associated with the Room Status feature.
COntrol System Class of Service upon check-in, Controlled Class of
Service upon check-out
E1 / E2 Enhanced Controlled Class of Service (1 or 2) upon check-in,
Controlled Class of Service Restriction level upon check-out
DNd Automatic cancellation of Do-Not-Disturb upon check-out
LAnguage Reset language to zero (0) upon check-out
MWl Message Waiting lamp turned off upon check-out
REquest Automatic cleaning request upon check-out
SL1 Allow use of SL-1 or digital telephone Controlled Class of Service
(CCOS) key for check-in and -out
TL Verify set is connected (BAD LAMP message is printed if a set
checked with the TL command is disconnected)
WAke Cancellation of Automatic Wake Up calls upon check-out
VIp Remove VIP status upon check-out
Use the abbreviations listed above in place of "item" in the commands listed
below.
To set check-in, check-out parameters:
SEt OPtion CHeck item (ON) <CR>
To set more than one option at the same time:
SEt OPtion CHeck item (ON) <CR>
To remove a check-in/check-out status option:
SEt OPtion CHeck item OFf <CR>
June 1999