Agilent Technologies 8590 Series Service Manual page 663

Table 15-2 Special Service Tools
Item
1 Board puller, two prongs to lift PC boards
2 Extender board, pin and socket, 20 contacts (two required)
3 Extender board, pin and socket, 60 contacts
4 Extender board, 22 pin edge connector, 44 contacts
5 Injector board
6 Crystal bandwidth shorts (set of three)
Components Needed to Build One Crystal Short
0.01 µF capacitor
6a
90.0 Ω resistor
6b
6c Square, single-connector terminal (two required)
6d Two-terminal connector body
6e 3/16 inch dia. heat shrink tubing, 1 1/8 inches long
7 Combination wrench, 5/16 inch, with slotted box end (two required)
8 Combination wrench, 1/4 inch
9 Open end wrench, 15/64 inch, open end
10 Torque wrench, break-away, 10 inch-pounds, 5/16 inch, open end
11 Cable puller, pry-bar style
12 Alignment tool, metal tip, plastic body
13 Alignment tool, nonmetallic tip, fiber body
14 Alignment tool
15 TORX hand driver with required T8 and T10 bits, included in TORX
driver kit with multiple bits (See tool-tip illustration)
*A = Adjustment, T = Troubleshooting, R = Replacement Procedure
†
The part number provided is a non-part number. This tool can be ordered from:
If you order a similar tool from your local supplier, it is important that the outside dimension of the wrench
be no wider than 0.518 inches. This allows the wrench to be used on semirigid cable connectors in confined
areas.
Chapter 15
Description
Assembly Systems Inc.
16595 Englewood Avenue
Los Gatos, California 95032
(408) 395-5313
Service Equipment and Tools
Service Equipment and Tools
Part Number Use*
03950-4001 A,T
5062-1999 T
5062-2000 T
08565-60107 T
5062-6421 A,T
5062-4855 A,T
0160-4832
0757-0400
1251-4182
1251-0689
0890-0029
08555-20097 A,R
8720-0014 R
8710-0946 R
†
R
40-60271
5021-6773 A,T,R
8710-0630 A,T
8710-0033 A,T
A,T
8710-1426 A,R
663